(2) Any rough or sharp edges, burrs, slivers or scratches,
rough die or grind marks.
(3) Any component fractured, buckled, bent, punctured,
malformed or damaged.
(4) Components not readily accessible for servicing where
required.
(5) Functioning component that does not operate as
intended.
(6) Parts not joined or connected as specified.
(7) Threaded fasteners broken, stripped, or fractured.
c)
Welding:
(1) Not type specified, incomplete, burn holes, cracked,
fractured.
(2) Slag inclusion, slight undercut, not smooth and
uniformed, scale or flux deposit not removed.
d)
Cover:
(1) Not counterbalanced to maintain an open or closed
position.
(2) Not provided with a vent in cover top and condensate
drip shield located under cover.
e)
Manually controlled Tilting Assembly does not operate as
specified to allow precision control during pouring or
dumping of pan contents.
3)
Capacity Test: The frying and braising pan(s) should be tested
to determine compliance with the capacity requirements of the
contract specifications. Fill the pan(s) with water at 10 C
(50 F) from a container or source of known capacity. Failure
to comply should be cause for rejection of pan(s).
4)
Load Test: Wall bracket and in-wall carrier assembly for wall
mounted pans should be capable of supporting 180 kg (400 pounds)
in excess of pan weight.
5)
Operational Test:
a)
Fill pan(s) approximately one-quarter full of cold water
(tap).
b)
Operate with the adjustable thermostat control set at each
temperature setting for 5 minutes.
c)
Observe the effect that each temperature setting has on the
water.
d)
Observe to insure that the controls will automatically
shut-off when the desired temperature has been reached and
turn on when temperature falls below the desired setting.
6)
Certification Compliance Examination: Certifications, certified
test reports, or listing marks for codes and standards, as
applicable, shall be examined and validated as proof of
compliance.
a)
Frying and braising pans should conform to the following
standards:
-
National Sanitation Foundation (NFS)
-
American Society for Testing and Material (ASTM)
-
American National Standards Institute (ANSI)
-
Underwriters Laboratories (UL), or compatible testing
laboratories.
11410.9
Previous Page
