Architectural:
Schematics*
DD**
CD***
Wall sections12
Building sections13
Finish grades at corners, entrances,
exits, platforms and ramps
Fire and smoke rated partitions14
Lead-lined and radio-frequency-
shielded partitions14
Fire extinguisher cabinets14
Spray-on fire proofing (see fire
protection)
Construction details15
Drafting symbols, abbreviations, and
general notes
Door, window, and louver schedules
Interior details, elevations, sections
Finish schedule16
Graphics and signage17
Color rendering
Specifications
Lead abatement18
Lead abatement specification19
*
Submit, as a minimum, a single line layout for at a scale not less than
1:100 (1/8 inch). A scale of 1:200 (1/16 inch) is acceptable for architectural
floor layout if an entire floor cannot be shown on one sheet. Submit a
complete double line layout of areas of critical importance, at a scale of 1:50
(1/4 inch) including equipment.
** Submit minimum 1:100 (1/8 inch) scale floor plans, new and renovated,
incorporating all of the revisions required by comments from schematics.
*** Submit fully dimensioned, complete, and coordinated 1:100 (1/8 inch)
scale floor plans, incorporating all revisions required by comments from the
design development phase.
B. NOTES:
1. Use lines between spaces to indicate the centerline of the partition (for
schematics only).
2.
Indicate doors with a slash mark.
3.
Along the corridor, the line shall represent the corridor side of the partition.
Program Guide, PG-18-15, Volume C
8
May 2006
Previous Page
