Final Draft 12-31-95
Revised May 1997
Design Standards
Automated Radiographic Room w/Control
ARCHITECTURAL
POWER (cont.)
Ceiling:
Acoustic lay-in ceiling tile
Notes: 3. 480V., 3P., 150A., adjustable trip
Ceiling Ht:
2890 mm (9'-6")
flush mounted circuit breaker with
Wall Finish:
Paint
shunt trip. Run empty 600 mm (2" C.
Wainscot:
--
from circuit breaker to x-ray duct
Base:
Resilient base
above finished ceiling.
Floor Finish:
Vinyl composition tile
4. 300 mm x 140 mm (12" x 5-") deep
Slab Depr:
100 mm (4")
flush floor duct with screw-on cover.
Notes: 1. 200 mm (4'-0") wide door. See VA
Connect to vertical wall duct.
Construction Standard 64-1, X-Ray
5. 250 mm x 140 mm (10" x 5-") deep
Radiation Shielding and Special
flush vertical wall duct with 300 mm
Control".
(12") wide screw-on cover. Connect
to floor duct and to x-ray duct above
SPECIAL EQUIPMENT
finished ceiling.
6. 250 mm x 140 mm (10" x 5-") deep
None
flush vertical wall duct with 300 mm
LIGHTING
(12") wide screw-on cover. Connect
to x-ray duct above finished ceiling
General:
30 FC
and terminate at finished floor.
Special:
--
7. 250 mm x 140 mm (10" x 5-") deep
Notes: 1. "X-ray in use -DO NOT ENTER"
x-ray duct above finished ceiling with
warning sign fixture.
250 mm (10") wide screw-on cover.
2. Continuous fluorescent direct/indirect
Connect to vertical wall duct.
wall mounted fixture, acrylic prismatic
8. Emergency Power Off (EPO) push
lens on top and bottom, W/2-F32T8
button station. Connect to shunt trip
lamps, 3500 deg. K, CRI=75 (min.)
circuit breakers.
3. Illumination level controlled by
dimmer.
COMMUNICATION
ADP:
--
POWER
Radio:
--
General:
1200W (receptacles)
Telephone:
Yes
Emergency:
1600W (receptacles)
Intercom:
--
Notes: 1. The electrical plan as shown is to be
Pub. Addr:
--
used as a guide only. Equipment
locations, dimensions and wiring
requirements to be per the x-ray
system suppliers equipment
installation drawings.
2. Electrical trades shall provide
necessary conduit, openings,
bushings, nipples, flexible conduit
etc., as required at the various
junction boxes, duct and conduit
terminations to allow proper
connections of the x-ray equipment
and related accessories.
VA DESIGN GUIDE
RADIOLOGY SERVICE
PAGE 4-8
Previous Page
