M2
.
Precast Manhole Drawings
We understand that the time and cost
.
Door Schedules
associated with sudden conversion of
.
Wall Paneling Drawings
handbooks and product literature can
.
Caisson Details
be significant, and have attempted
.
Millwork drawings
to avoid that.
.
Cabinet Work Details
.
Toilet Room Details
Class 3. Metric Supplement Required
.
Ductwork Submittals
Requires existing pre-printed
.
Pipe Installation Drawings
literature to be supplemented to
.
HVAC Schedules
show conformance with requirements
.
Switchgear Drawings
stated in the specification or on
.
Electrical Component Layout Drawings
drawings.
.
Signage Drawings
Supplements can be:
Class 2. Data That Must Be Metric Only
Following types of items must be
1.
Bond Paper Supplement
submitted in SI only.
2.
Handwritten Or Typed On Existing
Literature
Primarily, any data generated
3.
Other Approved Method
specifically for this project must be
submitted in SI only.
Examples:
.
Concrete Design Mixes
Steel Deck Data The entire product
.
Concrete Test Data
literature does not need to be
.
Core Bore Depths and Data
converted, only those numbers
.
Aggregate Mixes Must Show Metric
sufficient to show that the sizes
Sieves
submitted are those sizes required
.
Mechanical Air and Water Flow or
(such as 38 mm, etc). The bond paper
Balancing Data
supplement would state the 1.5 inch
.
Environmental or Hazardous Material
deck is equal to 38 mm.
Data
.
Most Test Data of various natures
Epoxy Adhesive Literature must only
.
Other data generated for this
show conformance with requirements
project, not in bound, preprinted
specifically shown in the specs.
catalogs or publications.
Preprinted Mechanical / Electrical
To absolutely minimize the time and
Equipment Catalogs need not be
cost impact of metric conversion, we
converted. However, conformance with
have recommended an additional class of
specified and scheduled flowrates,
submittal data.
pressures, temperatures, thermal
output rates, etc, must be
This allows us to meet the national
demonstrated.
mandate of complete metric conversion,
while allowing the extensive body of
Physical dimensions of mechanical
technical information to be fully
and electrical equipment shown on
converted over a period of a few years.
project specific installation
drawings are Class 1, and must show
metric only.
32
Previous Page
