C.
Chapter 3.
Sterilization Equipment
Section 11710 .... Sterilizers and Associated Equipment
1.
Sterilizers and Associated Equipment
a.
Symbols for this equipment are prefixed by "VS".
b.
Provide proper loading and servicing clearances for
all sterilizing equipment.
c.
Show location of sterilizers floor drains and sinks on
the architectural plans and coordinate with the
plumbing drawings.
d.
Coordinate ETO sterilizers exhaust requirements with
the HVAC drawings.
e.
Provide mineral-free water to washer-sterilizer for
final rinse.
f.
Use sterilizer enclosure panels (modular walls) for
recessing sterilizers in SPD, glassware wash rooms,
surgery, and other locations utilizing recessed units.
g.
Where pass-thru one wall sterilizers are used from
infectious area to other areas, use a cross
contamination seal at the wall end. Locate main
controls in the contaminated area. Provide detail of
cross contamination seal.
h.
Show elevations and details of sterilizers.
i.
Equipment must comply with the requirements stated in
specification 11710.
D.
Chapter 4.
Laboratory Washing and Miscellaneous Equipment
Section
11491 ..... Hydrotherapy Equipment
Section
11615 ..... Laboratory Controlled Temperature Rooms
Section
11620 ..... Laboratory Custom Fabricated Equipment
Section
11701 .... Solution Warming Cabinets
Section
11714 ..... Medical Washing Equipment
Section
11781 ..... Morgue Equipment
1.
Hydrotherapy Equipment
a.
Symbols for this equipment are prefixed by "HT".
b.
Show elevations of each piece of equipment as shown in
PG-18-6.
c.
Provide adequate clearances as shown in PG-18-6.
d.
Equipment must comply with the requirements stated in
Specification 11491.
2.
Laboratory Controlled Temperature Rooms (CTR)
a.
Symbol for this equipment will be defined with "CTR +
Set Temperature". Rooms should not be identified as
"refrigerator" or "freezer".
4
Previous Page
