Installation
Exterior Signs
Mounting:
Non-illuminated
Letters
Metal letters that are installed on
the exterior of the building should
be done with spacers behind the
letters. This will allow for rain to
run down the building surface
without creating streaking under
��������
the letters.
�������
The size and length of the studs
�����
are to correlate to the size of the
�������������
letter and the depth that's required
for installation on a particular
building surface.
Plaster and stucco building
���������
surfaces should have complete
������������
adhesive sealant application
����������������
�������������
around the stud, where it
�����������
penetrates the building, to prevent
water intrusion into the building.
���������
�����������������
Letters that are installed on wall
surfaces below 2438 mm (8 feet)
should be installed flush to the wall
with no spacers and additional
adhesive applied to the back of
the letters. This will increase the
security of the letters against
vandalism or theft.
50 mm (2") Min.
������������������
����������������
���������
�����������
�����������������������������������
��������������������������������
�����������������������������
���������������������������
Page2- 10-11
02/2005
Previous Page
